Anything in here will be replaced on browsers that support the canvas element

Set of brake shoes (without eccentric/short lug) Fiat 500 F-Giardiniara/600 D since 06/1964/750/850 (1966-69)

This article is available.
20.70 €
incl. 19% VAT excl. shipping to Germany / Deutschland
Recom. amount per car: 2
Item number: 08031

Set of brake shoes:

  • brake linings without eccentric
  • 1 axle
  • short lug

Keep your brakes and brake linings always in top condition. Therefore replace this safety-related component with the smallest signs of wear. If the free travel of the brake pedal is immoderately long or if one wheel shows essential differences to the others considering the brake force, let the whole brake system check by your mechanic.

The strength of the brake pads must not be less than 1.5 mm

. This product fits the following models:

  • Fiat 500 F-Giardiniera
  • Fiat 600 D since 06/1964
  • Fiat 750
  • Fiat 850 1966-1969

Other valuable tips can be found under the heading Maintenance and servicing!

The Brake Pads / Brake Shoes

Brake pads are part of the braking system. The braking system has the task of reducing the speed of the vehicle or bringing it to a stop. The braking system in modern vehicles is one of the most heavily stressed safety systems.

Brake shoes are commonly referred to today as the brake pads for drum brakes, which are pressed from the inside against the drum. Strictly speaking, brake shoes consist of the curved metal carriers of the brake pads and the brake pads that make contact with the brake drum. Usually, the brake pads are glued to the metal carriers, but there are also riveted versions. The brake shoes are located inside the brake drum - arranged opposite each other in pairs. One brake drum is responsible for slowing down one wheel.

When the brake is applied, the brake shoes are pressed outward against the rotating brake drum by one or two wheel brake cylinders. This creates friction, and the vehicle is braked or prevented from rolling. Due to friction - the kinetic energy of the vehicle is converted into heat - the brake pads are "worn off" and become thinner. If the brake shoes were not replaced, their brake pads would eventually be completely worn off, and when braking, the carrier material of the brake shoe would be pressed against the brake drums. Since the carrier material of the brake pads is usually made of metal - just like the brake drums - metal would then rub against metal - which is destructive for the brake drums and also highly dangerous - a total brake failure cannot be ruled out.

Brake shoes should always be renewed axle-wise - always right and left simultaneously, as otherwise, there may be different braking effects on both sides, leading to undesirable (and uncontrollable) effects on the vehicle behavior during braking. Therefore, manufacturers usually only offer brake shoe sets that include two pairs of brake shoes.

Fresh brake pads reach their full braking performance only after a certain break-in period. During this break-in period, the surface of the brake pad adapts to the surface of the brake disc/brake drum. The so-called "friction carbon" forms at the contact surface of the brake pad during this phase - the material at the contact surface with the brake disc or brake drum changes under the influence of friction and heat, improving the braking effect.

Recommendations - Accessories:

Brake cleaner Cartechnic, spray, 500 ml
This article is available.
4.30 €*  
(1 Liter = 8.60 €*)
 

Customers who bought this item also bought:

Wheel cover screw (47 mm)
This article is available.
3.90 €*
Recom. amount per car: 2
Set of breaker contacts
This article is available.
5.90 €*
 
Set of spark plug cables
This article is available.
29.90 €*
 
Rubber mounting for steering lever bearing block
This article is available.
4.50 €*
Recom. amount per car: 2
Front shock absorber
This article is available.
49.90 €*
Recom. amount per car: 2
Hood cable assembly
This article is available.
6.10 €*
 
Grommet for cables/cable pulls/hoses/speedometer cable
This article is available.
1.60 €*
Recom. amount per car: 5
Axle boot with metal bushing and radial shaft seals
This article is available.
8.00 €*
Recom. amount per car: 2

Legal note:


* Our offer is addressed to end consumers. So all prices are including value added tax and additionally freight costs.


Drawings could be alike. We can assume no liability to product informations. Pictured related equipment is not contained in the scope of delivery. Logos, descriptions and brands are property of the relative producer. Changes, mistakes and prior sale are subjected.