Zinc spray 'Presto', 400 ml, (-> 600°C)

Zinc spray 'Presto', 400 ml:

ATTENTION: Dangerous good !

Manufacturer's data:

Cold galvanization against corrosion. Excellent rust-protection for all iron metals, such as car bodies, exhaust systems, gates, machines, metal housings, metal fittings, fences etc. Especially suitable for the protection of welding seams and metals which are exposed to corrosion. For the colour-matching repair of zinc-plated surfaces, use presto Zinc-Alu-Spray.

Quality and properties:

• High-grade zinc coating with more than 90 % zinc share in the dry film
• Cathodic corrosion protection for all blank metals
• Resistant to highest demands against corrosion
• Highheat-resistant up to 600°C
• Particularly suitable for welding seams
• Ideal for all metals in outside places, which are liable to rust.

Physical and chemical data:

• Basis of the binder: Epoxyester
• Colour: zinc-coloured
• Smell: solvent
• Degree of gloss (at measurement angle 60° acc. to DIN 67530): matt, 5 gloss units
• Efficiency: Depending on consistence and color of the ground: 400 ml are sufficient for approx. 1.0 - 1.5 m² at covering layer
• Drying time (at 20°C, 50% relative air humidity): Dust-dry: after approx. 10 minutes Non-sticky: after approx. 20 minutes Coatable: after 24 hours Resistant to temperature: after 8-12 hours The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
• Temperature resistant: up to 600°C
• Storage stability: 10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
• Size: aerosol cans, maximum nominal volume 400 ml

Using instructions:

• The metal surface has to be blank and free from fat.
• Due to the high density, the Zinc Primer has to be shaked for at least 2 minutes after you hear the noise of the mixing-balls. Otherwise the valve could block.
• Shake the can vigorously for approx. 2 - 3 minutes.
• Test spray at an invisible spot.
• Apply several covering coats.
• Spray from a distance of approx. 25 - 30 cm.
• After drying (approx. 24 hours) apply primer and top coat.
• Do apply just thin coats to objects, which are exposed to high heat. If necessary, re-coat with temperature-resistant lacquer (test painting).
• Can be coated with itself; it is possible to apply a primer and a top-coat.

Hazard warning:

• H222 Extremely flammable aerosol.
• H229 Pressurized container: may burst if heated.
• H315 Causes skin irritation.
• H319 Causes serious eye irritation.
• H336 May cause drowsiness or dizziness.
• H410 Very toxic to aquatic life with long lasting effects.
• EUH066 Repeated exposure may cause skin dryness or cracking.